Aquatic Plant Central - View Single Post

Brendan Redler · 07-29-2008, 07:26 AM

After having used this setup for a while, I find it works better if I don't put the tubing where the flow rate slider goes, and instead cut out ONE of the slats in the side of the inflow guard and stick the tubing there. The hole where the slider goes is just too small, and as a result the tubing was pinched shut after a while. No problems since I placed the CO2 line in the side of the inflow guard.

07-29-2008, 07:26 AM	#102 (permalink)
Brendan Redler Senior Member Join Date: Jun 2008 Posts: 118 iTrader Ratings: 2 iTrader Positive Rating: 100% Plant Points: 8450	Re: Tiny super efficient CO2 reactor After having used this setup for a while, I find it works better if I don't put the tubing where the flow rate slider goes, and instead cut out ONE of the slats in the side of the inflow guard and stick the tubing there. The hole where the slider goes is just too small, and as a result the tubing was pinched shut after a while. No problems since I placed the CO2 line in the side of the inflow guard.