Very, very nice job, so far! You guys work like craftsmen. Now, you need to make doors, and there are several ways to do that without using a router or table saw.
One is to use rectangles of one half inch birch plywood, slightly bigger than the openings. You can find some thin flat strips of wood in the moulding section of HD, to cut to cover the plywood edges. Those, you can just glue on and use masking tape as the "clamps" to hold it while the glue dries. Then sand off any excess width of the strips and fill the cracks.
Another way is harder: make doors like that, but make them fit into the door openings with about one thirty second of an inch clearance all around. Finding appropriate hinges and installing them for this type door is more difficult, but you can do it with hand tools.
Just don't give up! You really have a nice stand going, even if it could be used as an elephant's chair!
