Originally Posted by Virc003
It's too big to boil unfortunately. About the best I can do is use the hot water from the faucet. I do work for an industrial heat treater though...I only see bad things happening from that. I was thinking forcing water through the vascular system with a hose attached to a cut end or maybe a pressure chamber should theoretically work, but I don't have the energy to put into that.
Is there a specific soak time for hot then cold? I can do warm then cold.
I did 20 min of a rolling boil, give or take, then cold water for a few. I changed out the water every time too and turned over the wood to boil the other end if I had to.