Custom Figured Cherry Veneer Stand

By: AaronT
January 17th, 2014
12:19 am

Custom Figured Cherry Veneer Stand

After purchasing the veneer for this project about 3 years ago I finally started on it this past fall. It's been slow going, but here's the progress on the stand thus far. The stand is a little bit longer than the tank (an ADA 90-P). Rather than the usual holes on the sides of the stand they will be on the top of the cabinet so the inlet / return hoses go straight down into the stand. A bit like the design on the bottom of this page, but only on one side.

The construction was done using 3/4" MDO plywood with the exception of the front header, which is solid cherry. All joints are rabbeted and screwed and glued using pocket hole screws. I'm still in search of some veneer that is wide enough to do bookmatched doors on the front. Excuse the glue residue. I applied the veneer using a veneer hammer and hide glue and have yet to clean up the excess. The solid cherry header is backed by a piece of 3/4" MDO plywood and is super strong. I can sit on the front in the middle and there is no flex and I'm about 185 lbs. The header has yet to be veneered as well. I chose solid wood there because at one time I considered doing a very slight bevel on it to mimic the bevels on the glass of the aquarium.

The inside will be painted either white or light grey as a nod to the ADA tank it will hold.



Join the Discussion!

15 comments on "Custom Figured Cherry Veneer Stand"

  • TropTrea
    December 25, 2014 at 1:18 am

    I really love the finish. Personally I have been afraid to work with Veneers even though they can beautiful like yours came out. With the cost of some of more beautiful veneers I'm afraid that I will not do the job done right and it will have problems. But your cabinet is an inspiration for me try using Veneers.

  • AaronT
    December 31, 2014 at 10:50 pm

    The veneer I used is not a premium quality, but its not terrible either. I think I paid $40 for 10 sheets on eBay. The hide glue was a tricky process, but also fairly inexpensive to experiment with.

  • TropTrea
    January 1, 2015 at 8:09 pm

    The thing I'm afraid of doing Lamination with is that I was told the lasting ability of the bond is directly related to the pressure applied during the drying process. I know someone that does small laminating plaques and he will only do pieces under 2 Square feet for this reason and he has a press that he clamps the pieces in over night.

  • k zeller
    January 5, 2015 at 6:00 pm

    Trop, Ive done many laminate countertops and still havent had any issues with them. I typically do 3 coats of the RED label DAP Weldwood contact cement on each surface allowing to dry completely between each coat. Put in place in a rolling motion and roll excessively with a laminate roller, can usually rent one from a rental shop for around $5 a day.

  • AaronT
    January 14, 2015 at 10:09 am

    I used a traditional hide glue application to apply the veneer. The veneer itself is not backed, but raw wood. It's a relatively cheap way to try veneering.



Post Reply
 

Search Engine Friendly URLs by vBSEO 3.6.1