Going to give a diy ada style stand a try. I'll post progress in case anyone else is interested in doing the same project. The drawing is loaded on sketchup. Following the guide below:
If you are open for suggestions. I build one myself. Something I would have done different in retrospect is the front bar (above the door). I made it just below the top panel as well, but it's way more beautiful to make the front panel all the way up till the aquarium. Unless you're laminating the thing, then it doesn't matter.
Another option is to use oak or another hardwood plywood rather than pine plywood and covering it with Formica. This is a personal taste issue as some like the look of wood over the look of Formica. Cost wise it will depend on the type of hardwood you select. The link lists three sheets of 3/4 plywood but 4 X 8 sheets sounds like a lot of wood. With watching you cuts two sheets should be enough. And looking at your dimensions one sheet is possible.
The thing though is with hardwood you want to watch the orientation of the cuts to keep the grain pattern consistent.
Check our Amazon.com Te last time I bought Formica I found that a sheet was cheaper through them even after shipping than buying locally. The selection of colors was also much wider from them.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Aquatic Plant Forum
730.4K posts
52.5K members
Since 2003
A forum community dedicated to aquatic plant owners and enthusiasts. Come join the discussion about collections, displays, tanks, styles, troubleshooting, reviews, accessories, classifieds, and more!