Aquatic Plant Central - View Single Post - Help Starting Paintball Co2 system.
View Single Post
Old 09-08-2019, 12:44 PM   #1 (permalink)
dawntwister
Senior Member
 
dawntwister's Avatar
 
Join Date: Sep 2007
Location: Mableton, Georgia, USA
Posts: 930
iTrader Ratings: 1
iTrader Positive Rating: 100%
dawntwister is a regular member
Red face Help Starting Paintball Co2 system.

I am very nervous about using this system. I am not using a solenoid. Regulator is WRCO2.
https://www.amazon.com/Interstate-Pn...01946375&psc=1

Uncertain what I should do 1st. Uncertain if I should 1st set the regulator to 30-50 psi or turn needle valve off 1st. Logic says to turn needle valve off 1st, but instructions I read some where say.

For no pressure in the post body system start up.
1. set the output pressure of the regulator at 30-50 psi.
2. close all needle valves, turn on the solenoid.
3. open the needle valve, slowly, monitor the bubble rate, every time you turn the needle valve,
dawntwister is offline   Reply With Quote

Advertisement [Remove Advertisement]