Aquatic Plant Central - View Single Post - Paintball CO2 Setup
View Single Post
Old 01-03-2011, 05:52 PM   #2 (permalink)
JEden8
Member
 
Join Date: Nov 2010
Location: Tampa, FL
Posts: 47
iTrader Ratings: 0
JEden8 is a regular member
Default Re: Paintball CO2 Setup

So I think I just found my answer:

AS IT CAME TO MY ATTENTION, EVEN THOUGH I DIDN'T HAVE A PROBLEM WITH ALL 3 OF MY PAINTBALL SETUP WITH THE WATTS-A41 NEEDLE VALVE, MAJORITY OF THE PEOPLE HERE HAVE HAD ISSUE WITH THE WATTS-A41 NEEDLE VALVE NOT HOLDING STEADY PRESSURE.

AS A NEW ALTERNATIVE NEEDLE VALVE, I MYSELF IS ORDERING IT TO TRY IT OUT SO I CAN HELP FUTURE DIY'ERS ON THIS SUBJECT OF MATTER, I OPT FOR YOU GUYS TO REPLACE THE WATTS NEEDLE VALVE FOR A SWAGELOK 1/8" Brass Needle Valve B-OVM2-BKB,WHICH CAN BE BOUGHT OFF EBAY FOR $8.99. WITH THIS YOU WILL NEED 2 ADDITIONAL PARTS FROM HOMEDEPOT UNDER THE MANUFACTURE OF WATTS WHICH PART NUMBERS ARE A29 AND A706, WHICH WILL COST UNDER $6.00 FOR BOTH.

Thought I'd post it for any others that are using this setup.
JEden8 is offline   Reply With Quote