After purchasing the veneer for this project about 3 years ago I finally started on it this past fall. It's been slow going, but here's the progress on the stand thus far. The stand is a little bit longer than the tank (an ADA 90-P). Rather than the usual holes on the sides of the stand they will be on the top of the cabinet so the inlet / return hoses go straight down into the stand. A bit like the design on the bottom of this
page, but only on one side.
The construction was done using 3/4" MDO plywood with the exception of the front header, which is solid cherry. All joints are rabbeted and screwed and glued using pocket hole screws. I'm still in search of some veneer that is wide enough to do bookmatched doors on the front. Excuse the glue residue. I applied the veneer using a veneer hammer and hide glue and have yet to clean up the excess. The solid cherry header is backed by a piece of 3/4" MDO plywood and is super strong. I can sit on the front in the middle and there is no flex and I'm about 185 lbs. The header has yet to be veneered as well. I chose solid wood there because at one time I considered doing a very slight bevel on it to mimic the bevels on the glass of the aquarium.
The inside will be painted either white or light grey as a nod to the ADA tank it will hold.