Aquatic Plant Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
3,252 Posts
What is wrong with end caps? Are you out of length? If so I think the best thing to do would be to solder the wires securly to the lights and use a section of heat shrink tubing for each pin. Make sure you slide the shrink tubing onto the wire before you solder;) I assume there are connectors that will fit the pins well but I don't know. If you don't have space for the waterproof endcaps, look at the regular endcaps. They only cost $3 and make life easier and safer.

As Andrew said, awesome job from a valuable member of our community.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top