Joined
·
311 Posts
Just run to Petco or some place similar and by some of that hard 1/8" tubing and make a getto counter:
Parts:
1/8" hard clear tubing (Petco, Petsmart, etc...)
1 DIET Coke bottle
1 tube, plumbers goop.
1) Cut one piece of the tubing ~1-1 1/2" long
2) Cut one piece of the tubing ~6-7" long
3) Poke (1/8" Drill works better) two holes near the middle of the soda bottle's cap.
4) Insert tubes so that about 1/2" is sticking out the TOP side of the cap.
5) Apply enough plumbers goop to ensure you get a good seal
6) Let goop dry
once dry,
7) fill soda bottle almost all the way with water
8) Connect supply side of CO2 to longer pipe (Note: first, I sometimes heat up the hard tubing over a flame enough to get it malleable to put a small bend near the bottom)
9) Connect tank side (with check-valve) to short tube.
10) Screw cap to bottle
11) Voila!
- Jeff
Parts:
1/8" hard clear tubing (Petco, Petsmart, etc...)
1 DIET Coke bottle
1 tube, plumbers goop.
1) Cut one piece of the tubing ~1-1 1/2" long
2) Cut one piece of the tubing ~6-7" long
3) Poke (1/8" Drill works better) two holes near the middle of the soda bottle's cap.
4) Insert tubes so that about 1/2" is sticking out the TOP side of the cap.
5) Apply enough plumbers goop to ensure you get a good seal
6) Let goop dry
once dry,
7) fill soda bottle almost all the way with water
8) Connect supply side of CO2 to longer pipe (Note: first, I sometimes heat up the hard tubing over a flame enough to get it malleable to put a small bend near the bottom)
9) Connect tank side (with check-valve) to short tube.
10) Screw cap to bottle
11) Voila!
- Jeff
