Aquatic Plant Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
153 Posts
I used 3/4 inch pvc pipe. I put the fittings together and glued them. I drilled the end cap block off to fit a barbed screw in fitting. I threaded the metal fitting into the pvc endcap. I marked at one foot intervals a marker dot and where I needed a tap I drilled it and inserted a cap. The pump is connected to the pipe through a plastic tubing piece. I dont know what the output of the pump is but I ran 15 or 20 smaller tanks off it with mattenfilters. No tanks were bigger than the one 55 and one 30. The rest being tens and 20s.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top