Aquatic Plant Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
121 Posts
Discussion Starter · #1 ·
I need some advice for a CO2 Needle valve to help regulate the flow of CO2 once I go Pressurized. I have looked at the one sold on DrsFostersmith and found the price to be steep. about 37.00 before shipping. I was wondering if anyone had any ideas either for a DIY or some pre made needle valve that is less than what was listed above. Basically I am looking to find one that will allow control down to 1-2 bubbles a second. I already have my regulator and solenoid, but now need the needle valve. I have tried a basic plumbing needle valve, but even the smallest is threaded to large to keep the flow at 1-2 bubble/sec. Any help would be great. Thanks!

Sean
 

·
Registered
Joined
·
122 Posts

·
Registered
Joined
·
121 Posts
Discussion Starter · #7 ·
Everyone thanks for the help. Someone had an extra one so I purchased for what I could afford. Thanks again all for the help. This site is unbelievable for the amount of help a person receives in a short time.

Sean
 
1 - 8 of 8 Posts
Top