Aquatic Plant Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
69 Posts
Discussion Starter · #1 ·
Hey there... me again... lol.

What level of CO2 should be leaving the regulator to the pin valve?

The system should be here Monday or Tuesday, and I don't want to blow something out. That'd be bad.

Any other tips before I piece it all together?

Also, loctite, or teflon tape? Or neither?

-MT
 

· Registered
Joined
·
3,252 Posts
5-20psi leaving the regulator. This all depends on how many lines you have and what type of needle valves you use. I run mine about 20 using clippard needle valves but thye work fine at lower pressures.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top