Aquatic Plant Forum banner
1 - 1 of 1 Posts

· Registered
96 Posts
Just a quick thought on the air in the top of the reactor.

Couple things that you could probably do to stop it:

1) increase the inlet tube size to allow more water in than out

2) flip side is to decrease the outlet tube size or increase resistance on the outlet side (ex spray bar)

3) install some sort of air vent to periodically bleed the air.

I use a dedicated powerhead with an inline reactor. 1/2 tubing to and from
I also crafted a spray bar which slows the water down on the output end.
Ever since I 've burped the reactor there has been water up to the check valve installed on the CO2 tubing.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.