Aquatic Plant Forum banner

DIY HD light not working with T8

4985 Views 13 Replies 8 Participants Last post by  xtremefour
I have a couple of questions so please guide me....

I made my own DIY light using a shop light from HD. I went out last night and had enought money for one 48" T8 Aqua Glo bulb. When I put the bulb in only the very ends light up and my balast makes a buzzing noise. I had done some reading about rapid fire balast verse electronic balast. Mine is a rapid fire. I am assuming this is why my bulb will not light. I put a crappy regular 48" in there and it worked fine.

Question: Should I return the bulb and go to HD for some of their bulbs? I heard they had good bulbs for plants.

I heard that I could use the wires that would be for the 2nd bulb and wire it up for the first bulb so it would "overload" and I could still use the bulb i bought. Is that right? Can I just go buy an electronic balast to do both lights?

My tank is in severe need of light. I have a 75 gal at the moment with two 15 watt Aqua Glo lights. This is what was given to me when I bought the tank.

Thanks you,

1 - 1 of 14 Posts
just return the ballast and get an electronic ballast. just make sure it can handle the wattage you're intending to power.

and it doesn't hurt to ask a HD employee for advice.
1 - 1 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.