Aquatic Plant Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
612 Posts
i'm using a stealth but there is a bit of an issue since it has 4 ridges that run the length of the heater. just makes it a little more difficult to get a good seal.
I use the Stealth in mine, the ridges are soft plastic. carefully cut them off and the seal works great. I use a sharp chisel to trim the ridges so it won't cut to deep.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top