Aquatic Plant Forum banner
1 - 1 of 1 Posts

· Registered
742 Posts
Thank for your design...

now my thinking is that if you curve corner the front panel...that you would need slightly longer front panel right? say if you wanted it 2 x 4 x 2..... then you might need it a lil longer than 8 inches? is that correct or 8 is fine?

also, how do you mark and know exactly where to make the bend to be accurate enough so that the edges of the front panel are flush after you are done...
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.