Aquatic Plant Forum banner
1 - 1 of 1 Posts

· Registered
5 Posts
Discussion Starter · #1 ·
Picture shown is my diy solenoid regulator converted from manual regulator. So far this baby working fine and no leaking at all. Just that after the solenoid valve shut off the working pressure gauge slow rise till more that 10bar. And my CO2 output is 0.5bps adjust using adjuster at manual regulator. So what have I miss or is this normal that it will equalize between two pressure?

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.