Aquatic Plant Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
2,988 Posts
Discussion Starter · #1 ·
ANybody know what id size of tubing fluval uses. I have a 104 that i want to add a CO2 reactor inline to. What size barbs and how do you keep them leak free. It has a very odd ribbed tubing. Do you just replace their tubing with regular clear tubing?

Thanks:)
 

·
Registered
Joined
·
2,250 Posts
Dennis,
I had one of the early 304's that had the clear tubing...and since the tubing is still hanging in my garage it looks to be 5/8" id. I also measured the ribbed tubing, and the end connectors look to be 5/8" id as well (Better have been since the ribbed was used to replace the clear :) ).

HTH.

--Mike
 

·
Registered
Joined
·
426 Posts
dennis said:
What size barbs and how do you keep them leak free. It has a very odd ribbed tubing.
The key to keeping them leak-free is the hose clamp. It is usually available in the same section as the tubing and barbs (Plumbing).
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top