Aquatic Plant Forum banner
1 - 1 of 1 Posts

· Registered
24 Posts
Discussion Starter · #1 ·
Below is some information I have collected from Internet, contributed by Chuck Gadd, hope this will be use full for you.

When aquatic plants are growing well, they will consume the nutrients that are available in the water. These nutrients fall into two categories: Macronutrients and Micronutrients. Macronutrients are those which the plants needs in large amounts. Micronutrients are needed in very small amounts. Micronutrients are also known as trace elements.
A quick side-note about requirements for plants: In addition to the macronutrients and micronutrients, plants also need CO2 and light in order to grow. In fact, CO2 and light are MORE important than any of the nutrients. Plants that do not receive enough light will just turn brown and die. No amount of fertilizer will help in that situation. But most beginners who add live plants to their tanks will attempt to improve the plant growth by adding some fertilizers, since it's much easier to add some liquid from a bottle than it is to add more lighting to an aquarium. Don't repeat this mistake. The only thing you will grow is more algae!
Now back to the fertilizers.

Macronutrients and Micronutrients

The Macronutrients consist primarily of Nitrogen, Phosphorus, and Potassium. These nutrients are all needed for plants to grow. In an inhabited aquarium, fish food and fish waste will provide some of each of these.
As you hopefully know, fish produce ammonia as waste. And as you hopefully know, bio-filter bacteria in the aquarium convert ammonia into nitrite, and other bio-filter bacteria convert the nitrite into nitrate. All three of these ( ammonia, nitrite and nitrate) are forms of nitrogen, and all can be used by plants. In most non-planted or lightly planted tanks, the nitrate level will slowly rise, and the aquarist must do water changes to lower the nitrate level. Nitrate levels over 20ppm can be harmful to fish.
In the case of a heavily planted tank, with lots of fast growing plants, it's possible for the plants to completely consume all the nitrogen produced in the tank. In that case, the addition of nitrate is needed to keep the plants growing happily.
In a well lit tank, excess phosphorus (phosphates) can lead to serious algae problems, so extra phosphate is almost never added. And most fish foods contain sizable amounts of phosphorus, so the plants will most likely be able to get as much as they need.
Potassium is an important macronutrient, and it is commonly in short supply in an aquarium. The amount of potassium from food and waste is often much less than the amounts of nitrogen or phosphorus. So adding potassium is often a good idea.
There are several commercial aquarium plant additives that contain potassium. You can also obtain Potassium Sulfate (K2SO4) or Potassium Chloride (KCl) from a gardening store as a source. K2SO4 is often referred to as "Sulfate of Potash", and KCl is referred to as Muriate of Potash. I only recently (in the past couple months) starting adding potassium, and the improvement in plant growth and health has been amazing.

There are main micronutrients. They include Boron, Calcium, Chloride, Copper, Iron, Magnesium, Manganese, Molybdenum, Sulfur, Zinc. These nutrients are often found in small amounts in tap water, and in low growth conditions, it isn't necessary to suppliment them. But with improved plant growth, these nutrients will be quickly depleted from the water, and plants will suffer. For the Micronutrients, there are many commercially available fertilziers. My favorite of them is Tropica Master Grow (TMG). It contains iron, manganese, magnesium, sulfur, boron, zinc, and molybdenum (spelling?). Others are available from Seachem (Flourish), and Dupla (Dupla drops). Alternatively, many people make their own. This is known as PMDD (Poor mans dosing drops). The starting point for PMDD is a trace element mixture. I use one called Microplex. Another common one is Plantex CSM. These are often available from Hygroponics suppliers. More info on PMDD is available at: The KribRegardless of what you use for micronutrients, these are typically added every few days. This is important because the iron and other elements will not remain available in the tank water for more than a few days. Dosing of micronutrients is commonly done based on the Iron level. The mixtures are all created so that by adding the right level of Iron, then the other elements will be present in the proper amounts.

Forms of Fertlizer
There are two commonly used forms of fertilizer for the aquarium: Substrate fertlizers and liquid fertilziers. The substrate fertlizers are those which are inserted in some solid form into the substrate. The liquid fertilizers are added directly into the tank water.
Substrate Fertilizers

One of the benefits of substrate fertilizers over liquid fertilizers is that when properly used, the substrate fertilizers are only available to plant roots. Since algae doesn't have roots, it can't get to the nutrients buried in the substrate.
Substrate fertilizers come in many different forms:
• There is a powdered substrate additive known as laterite that can be mixed with the lower level of gravel to provide a source of iron that plant roots can get to. It's important not to use too much laterite, and not to use it in the upper layer of the substrate, or it will leak into the water, and cause VERY high iron levels, which will lead to algae problems.

• Another common substrate fertilizer comes in tablets or sticks. These "plant tabs" or sticks are sold specifically for aquarium plants, "PlanTabbs", Seachem's Flourish Tabs, and Tetra's Hilena Initial Sticks. These are normally intended to be placed every couple of inches through out the substrate. Some of these tabs provide iron, some provide macro nutrients.

• The last common substrate fertilizer is a "plant spike". These are actually sold for normal household plants, but certain varieties of them are especially useful for aquatic plants. These are sold in the gardening section of many stores. The most commonly used ones are "Jobe's Plant Food Spikes for Lush Ferns and Palms". This variety has a very low phosphate level, which is important, since an excess of phosphate will quickly lead to algae problems. The Fern and Palm sticks also contain very little urea, a toxic form of nitrogen. Other varieties of the plant spikes contain much more urea, to the point where enough might enter the water and could harm fish. These are solid "spikes" that get pushed into the substrate where their nutrients are available to plant roots, but not to algae in the water. These plant spikes provide macro-nutrients only. When using these, they should be used sparingly, only at the base of heavy root feeding plants. Do not insert these over the entire substrate.
Liquid Fertilizers

Liquid fertilizers are often an important source of nutrients foraquatic plants. Many aquatic plants have specially developed to be able to efficiently consume nutrients from the water. Some plants don't grow roots down into the substrate, and so their only source for nutrients is from the water. Most liquid fertilizers are intended to be added frequently, normally daily or weekly.
There are a variety of different liquid fertilizers available for a planted aquarium. Most of the commercially available liquids contain micronutrients. Some liquid fertilizers are available for adding potassium. I am not aware of any commercial liquid fertilizer that contains nitrates or phosphates. This is because those nutrients must be more carefully controlled to avoid algae problems.
When using a DIY form of fertilizer, like PMDD, or when adding potassium or nitrogen from a non-commercial source, the dry ingredients are usually prepared into a liquid form. Dry powdered chemicals are mixed in measured quantities with a known amount of water. Then a small amount can be added as needed.
Special warning!

Some people have asked about using common household fertilizers like miracle-gro in their planted aquarium. This is a bad idea, since most terrestrial plant fertilizers contain high levels of phosphates. In addition, many of them contain their nitrogen in the form of urea, which is essentially ammonia. And in a tank that contains fish, urea or ammonia is toxic. I've tested miracle-grow in an uninhabited 10g tank, and adding just 5ml of the liquid to the 10g resulting in ammonia levels off the chart for my ammonia test. The same hold true for many hydroponics fertilizes. I would suggest that you never add any fertilizers to your tank unless you are sure you know what it contains.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.