Aquatic Plant Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
71 Posts
Discussion Starter · #1 ·
I just set up my Milwaukee MA957 and i set the working pressure on the right gague to about 10psi but it keeps slowly falling back towards zero. Is this normal? Is there a certain way i am suppose to set it? I can constantly see the needle on the right gague tick and fall a little bit... and then it goes back up. I hope it's not damaged.. i loosened the adjustment knob all the way before releasing the cylinder valve just like the instructions said.
 

·
Super Moderator
Joined
·
7,436 Posts
I had similar problems with that regulator, but when I increased the outlet pressure to about 20 psi, the problems went away. It doesn't seem to be stable at 10 psi.
 
1 - 2 of 2 Posts
Top