removing the supportive glass from my tank

1325 Views 1 Reply 2 Participants Last post by Sir_BlackhOle, May 19, 2004

freshreef

Discussion Starter · May 19, 2004

its a 60*50*50 cm tank glass only - on top of it there is two supportive pieces of 15*50cm attached with silicone to the sides to support the whole tank ( maybe ??) - do u think i can remove them completly? if not- can i remove them to make them smaller (say 4*50 cm ), even one by one.
more info -
the glass is 8 mm thick and i fill the tank 42 cm - so its 126 liters only or about 30gal.

Save

1 - 2 of 2 Posts

Sir_BlackhOle

· #2 · May 19, 2004

Usually that center support is needed to keep the tank from bowing out when filled with water. You may be able to get away with using a smaller piece, but I wouldnt mess with it much if it were my tank. Hope that helps.

Save

1 - 2 of 2 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Home
Forums
General Interest Forums
Equipment

Top Contributors this Month