Aquatic Plant Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
4,116 Posts
Discussion Starter · #1 ·
I made a DIY canister filter and it works good but if I substitute the PVC barbs with acrylic connections the whole thing would look better and probably be less prone to leaks.

Where should I look for glue that binds acrylic?
Also - where can I find acrylic pipes - 1/4 or 1/2" size?

--Nikolay
 

· Registered
Joined
·
4,116 Posts
Discussion Starter · #4 ·
Ok, I found extruded acrylic but the cast one seems to be a problem.

What is the difference in regards to acrylic usage in aquariums?

--Nikolay
 

· Registered
Joined
·
4,116 Posts
Discussion Starter · #7 ·
Art and Gnatster, thanks for the prompt responses but I have not found any cast acrylic tubes with od of 1/4 to 3/4.

--Nikolay
 

· Registered
Joined
·
4,116 Posts
Discussion Starter · #9 ·
Art,

I'm trying to make a DIY canister a better looking piece of equipment. The lid and the canister that I use are clear acrylic, more or less like this one.

I don't know if that jar is extruded or cast. The in- and outflow of the filter as it is now are made of PVC fittings and O-rings. It'd be nice to have the whole thing made of acrylic. But the smallest cast acrylic pipe that I see is 1-1/2" od...

--Nikolay
 

· Registered
Joined
·
4,116 Posts
Discussion Starter · #11 ·
Then what would be a good glue for the PVC/acrylic joint? PVC cement or an acrylic one?

--Nikolay
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top