Aquatic Plant Forum banner
1 - 4 of 10 Posts

· Registered
Joined
·
444 Posts
Discussion Starter · #1 ·
I need to pick up 2 250W heaters for a discus tank, one in the overflow and one on the opposite corner of the tank. I've liked and had good experience with Stealth heaters, and like that they are black and easy to hide, have a non-breakable surface and shut off automatically when out of water and turn on automatically when back in water. I think the Ebo Jagers might generate more heat more quickly, but my only objection is that they are glass and if out of water due to a water change, I'm afraid they could break easily. Any thoughts?
 

· Registered
Joined
·
444 Posts
Discussion Starter · #3 ·
I would think the ones 10 years ago were probably made with higher quality, if older technology. The new Ebo Jagers are made of glass that's only a few mm thick. I'm 100% sure you could break one on the edge of a table without a lot of force. Also, have you ever tried taking your Ebo Jager out of the water and into the air when it's heating? If it's glass, I'm afraid there's a high probably it would break.

Have your Ebo Jagers been dependable and temp accurate?

Has anyone been using the new black Ebo Jagers for over a year?
 

· Registered
Joined
·
444 Posts
Discussion Starter · #6 ·
Based on feedback here and from others, going to stick with the Stealth. Only considered the Ebo Jagers because a reef LFS guy kept pushing them, saying he thought Stealth heaters couldn't produce the heat needed because they wouldn't burn him when he touched them. What a great criteria (NOT!). The Stealth slow even heating + a sensor connected to an off switch is probably what allows them to survive water changes without being shut off.
 

· Registered
Joined
·
444 Posts
Discussion Starter · #9 ·
It's for a 125g setup, and since one of the heaters will be hidden in the overflow box, which is a high flow area, only one will be inside the display area itself, but easily hidden along bottom or corner by plants or driftwood. I was thinking of going with a Hydor in-line, but then I read and heard a lot of comments about poor reliability and clicking on/off. I know people who use the Hydors, but then I've heard of too many people reporting problems with them. In my case, they're a lot of extra expense when neither of my heaters will be visible.
 
1 - 4 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top